The RCM-100 has a communication connector that can only be accessed when the unit cover is removed. This connector allows the dedicated programming device to configure and setup the unit. The case offers sealing against water entry. Cable entry will be by means of a small hole on the base of the case. This must be adequately sealed after installation to maintain the water sealing in those installations that require such protection.

The RCM-100 Single and Dual Unit has an output for connecting to an Automatic Meter Reading device such as RF Transmitters for both.

The serial number, make, device identification, manufacturer and model number are contained on a label that is fixed on the inside of the clear cover that cannot be changed or removed once the unit is installed. The PCB is permanently fixed to the inside of the unit under the label and is not removable.

The unit is equipped to indicate any and all unauthorized tampering with the wire, the meter register, and the security sealed cover. In either instance, a tamper indicator is displayed on the LCD display depicted by a large X at the extreme left of the LCD display. Only the owner or operator can reset and erase the tamper code using the RCM Programmer, as no other device can access the program. With each unit a State Approved Adhesive Security Seal can be used if required for dual tamper protection.

All spools are coated inside and out according to frame specifications and select spools are configured with straightening vanes to minimize or reduce turbulence and allow for conformance with AWWA specifications and recommendations.